Hi guys, wondered if anybody had got any of these tins? They are the little bit's of tin wear that go in-between the cylinders and push-rods!

Cheers Rob

I have a pair of these. I just dropped them to the powdercoated on Thursday. Was going to put them up for sale when I get them back. Probably two weeks.

there is a pair here Rob from a part engine I broke up as scrap.  how urgent do you need them could pop them in the post for you.

Quote from: snoopy on November 15, 2014, 08:20:09 PM
there is a pair here Rob from a part engine I broke up as scrap.  how urgent do you need them could pop them in the post for you.

Cheers for the reply Snoopy, let me know how much I owe you and I'll get some monies to you  Many thanks, rob

Quote from: parmaynu on November 15, 2014, 08:02:04 PM
I have a pair of these. I just dropped them to the powdercoated on Thursday. Was going to put them up for sale when I get them back. Probably two weeks.

Are these going to be black or some exotic colour? I can not believe I have run out of these, let me know how much you want for them when you get them done.

Cheers, Rob

Rob. Pm your your address as I cannot find where I had it. No worries about the cash.

I also need a set of these for my 2054 build if anyone elese has some.

Sorry rob for asking on your thread just thought I'd save an additional thread asking the same, hope that's ok

Dav

Posted them this morning Rob, the lady in the PO tried her parcel width go nogo scale and said no so  stuck another £1.40 on to my home calculation.

Quote from: snoopy on November 17, 2014, 04:26:26 PM
Posted them this morning Rob, the lady in the PO tried her parcel width go nogo scale and said no so  stuck another £1.40 on to my home calculation.

That will be two drinks I owe you then 

Many thanks, Rob