hi im wanting to wire up fuelgauge i have standard beetle tank and clock sender unit on tank has one pole for a wire please explain the back of clock has a little oblong box i left it alone ive wired up everything else an all work ok i just wasnt brave enough an didnt want my hard work going up in smoke  thanks guys

hi all the hose from the resvior down to the mastercylinder make sure the pipe you use is suitable for brakefluid if it isnt dont use it brakefluid will rot the pipes rubber ect ive learnt the hard way the correct pipe is blue  just kamper sell also cool air

hi ive replaced master and front wheelcylinders ive also put new pipe from fluid resavoir to mastercylinder wheel cylinders were ceased replaced them first couldnt get brakes to bleed up found mastercylinder was full of black bits id used wrong pipe that fed master had it in 3 years brake fluid rotted pipe
now had cylinder an master  still cant get it to bleed up im using dot 3 fluid pedal just goes to floor ive clamped front flexis an. then get some pedal try same on rear no pedal also ive set the adjuster on the the pedal so i felt it touch master and then wound it back a little so slight free play aaaaarrrrggg its doin my head in now any help thanks in advance

hi I'm doing the rear torsion bar can I remove both sides at same time so I can mark them up  I've done them an one side is higher so it's back to the drawing board thanks Alan

it's the rear end thanks

thanks for advice Alan

hi all I believe I need to move the bars to lower I have lab rat  which side goes forward an which goes back thanks I'm putting new bushes in should I use copper grease or something thanks 4 advice Alan

hi all when adjusting the splines do both sides go forward or does one go forward an one go Back if so which side does wich chears

I have Ali frame any. idea were I can get proper fixings from it has 2 channels to slide on

hi I took my tank to radiator fabrication place they soldered filler neck in place to match hole in bonnet hope it helps

hi all I'm about to set about making a rollcage I have lwb rat tips tricks will be great help thanks in advance al

I have fitted rear seatbelts to my lab  fibre fab I made a bar an fitted it over gearbox it is held by the two top gearbox/engine bolts it is solid an holds lap belts well no chance of bar bending is thick angle iron will this be ok 4 mot

hi thanks for wiring diagram wired it up have a brown wire coming out of motor is this earth or were does it go wipers not working should I run an earth to motor body thanks

hi all I have standard vw wiper motor need some longer wiper arms as the standard wiper arms/ wipers sit low down an catch frame I'm going to hunt round scrap yard any ideas what will fit

hi all can ya help I have two speed wiper motor wires are brown green black yell/black an grey/ black   I have vw wiper switch number 31 31b 30 53 53a 53b this also has washers on it what goes were thanks 4 ya help