Hi, whilst I'm prepping the chassis, was wondering if it's better to run the front to rear brake line through the tunnel.
I did
and no problems in 20 years.
Chad
Quote from: Chad on September 21, 2018, 01:03:46 PM
I did
and no problems in 20 years.
Chad
Interesting. How did you route the pipe Chad and how did you thread it through?
Cheers Chad
Hi Mark,
I did it when it was a bare chassis. I simply drilled a hole in the headstock and threaded the pipe through whilst looking down the tunnel through the front plate area.
Then a couple of cable ties where possible, a short piece of fuel pipe oround the brake line where it exists the chassis and all done
Chad
Quote from: Chad on September 21, 2018, 10:50:49 PM
Hi Mark,
I did it when it was a bare chassis. I simply drilled a hole in the headstock and threaded the pipe through whilst looking down the tunnel through the front plate area.
Then a couple of cable ties where possible, a short piece of fuel pipe oround the brake line where it exists the chassis and all done
Chad
You make it sound so simple ;D ;D ;D
I will give that a go ;-)(-;
Quote from: Zip Buggy on September 22, 2018, 12:30:43 AM
Quote from: Chad on September 21, 2018, 10:50:49 PM
Hi Mark,
I did it when it was a bare chassis. I simply drilled a hole in the headstock and threaded the pipe through whilst looking down the tunnel through the front plate area.
Then a couple of cable ties where possible, a short piece of fuel pipe oround the brake line where it exists the chassis and all done
Chad
You make it sound so simple ;D ;D ;D
To be fair, I didn't say how long it took me ;D ;D ;D