Very cool

Looking nice mate! Had the very same thought about carpeting the floor yesterday and just seen it on your thread! Was the carpet pre made or was it just some thing you cut out?

Looking nice mate! Had the very same thought about carpeting the floor yesterday and just seen it on your thread! Was the carpet pre made or was it just some thing you cut out?

carpet came as a big flat sheet .... had to cut it to fit .... I would never want to do it again as it's proper hard work mate 

hope this helps you .. sparky_lewy

Thats looking a neat job 

Side panels are fab Been looking to do the samefor a while. How did you secure to the tub 
Great job

Side panels are fab Been looking to do the samefor a while. How did you secure to the tub 
Great job

25mm panel clips 

not much to report really, had a chance to replace all the cv boots (as 2 were leaking.....  inspected all the joints etc .... cleaned out all the old crap from the bearings & fresh new graphite grease applied........ little lick of paint to the shafts

replaced the old fuel lines today.....













and a bit more tidying up

[My Youtube channel]

Just noticed, that Bowden tube doesn't look to have much of a curve in it. Gear changes etc all ok? 

Just noticed, that Bowden tube doesn't look to have much of a curve in it. Gear changes etc all ok? 

hi andy, gear changes seem ok to be fair .... no jumping or vibration etc

[My Youtube channel]

  cool.

Buggy looking good as ever!

warwick retro ......



photo taken by jamie outside machine7 ... when picking up the r9 fuel line kit

You're just a big show off Mr Toosh ! And I'm NOT jealous ?!

You're just a big show off Mr Toosh ! And I'm NOT jealous ?!

i'm only showing off the engine bay artwork ........