Hi all,
I'm Need your help locating where approx to weld the seat belt socket lugs on the centre spine of a shortened pan.
Does anyone have any pics or measurements. I will be using bug inertia belts with 30cm wire rope mounted seat belt buckle sockets.
Unfortunately I am unable to mock up with seats, but need to put the lugs in before painting the chassis.
Cheers in advance.

Matt

It will depend on your seats as sometimes the seatbelt mounting stops the seats going in or back fully as they are on the start of the flared section where the tunnel widens but if you have long stalks the catch can be higher then the seat with the mounting near the floor under the seat body.