Quote from: Manxdavid on October 28, 2017, 09:31:19 AM
Buy a new rod, rod length is critical to correct fuel pressure. Too long by a fraction and fuel pressure will be too high, too short and it'll be too low.

Brought two new rods to be on save side so new on that side

Fitted pump put rod at highest point then placed on top not much gap tighten down moved crank by hand and no tight spots
So fired up runs OK just need to know the correct way everybody runs fuel line at moment runs threw fan cowl lh side
And what 's the best wst to check fuel pressure just as a procutoin looked a car stand all good drops nice also greseed lever on pump
Thanks

Is it best to place it on top stock and see if pump lay on with out bottom out
But on pump I have is b for 100 mm well that what it's say on Web site as the pump I had was the original vw one and now this one is a sealed unit

Thanks Rob for reply thought you could but as new to thus wanted to nsk sure hoppully bug will be running Tom
Didn't fancied a trip back Tom

Hii all brought a fuel pump today but my push rod is 108 mm and pump is for 100mm push rod
Can I just cut mine down or should I exchange pump

Thanks chimp nice a neat job on build tread

What type off relay holders do peple use as looking to install some but no rpt knowing the best type to use

Thanks snoopY much appreciated

moose 

not been on for a while
I have a short wheel Base project going on but due to other things going on
I have decided to sell all as a project shaggy did come down and have a look a long time ago
to have a look all is there but in bits complete 1300s engine new floor pans
it's 1972 on log book as a salon so tax free open to offers but I like £1300 or a sensible offerer
thanks  moose man

Quote from: snoopy on September 25, 2015, 05:32:36 PM
Due to the theft of the engine when the car was stripped for refurbishment I have somebody after a complete engine everything fitted ready to bolt in it is for a K reg beetle but any twin port ideally.

Hi snoopy
not been on for a while just reading posts and noticed that engine is required
I have a short wheel Base project going on but due to other things going on
I have decided to sell all as a project shaggy did come down and have a look a long time ago
to have a look all is there but in bits complete 1300s engine new floor pans
it's 1972 on log book as a salon so tax free open to offers but I like 1300or a sensible offerer

Thanks for time to read moose man