Morning All
I have a question about the back part of my Chassis as to what I can safely take off and undo to to give me access to clean it down ready for painting. I am only doing it buy hand with Hammer-rite. Are their bit that I just should not undo or others I can take out a couple of bolts clean and then put them back ?
(http://i1080.photobucket.com/albums/j335/djdunkyd/DSCF0860_zps14de6f9f.jpg) (http://s1080.photobucket.com/user/djdunkyd/media/DSCF0860_zps14de6f9f.jpg.html)
You can take the gearbox out with the swing axles as one a simple enough job refer to a work shop manual as the axles have to go back in to the same position as they came out you can mark the position with a cold chisel before you start. Good luck with the refurb. ;-)up
As said box and shocks are easily removed and refitted just needs the brakes bleeding afterwards. One observation your clutch outer flexy tube needs to have more of a bend in it or you will suffer from judder on taking up drive plus one other the joints on the drive shaft boots want to be a 3 or 9 o clock not 12.