Well it had to happen.... Cannot find the original donor Beetle Handbrake Lever. Has anyone got one they don`t need?
Found the ratchet, spindle and cable equalizer. Need the lever, push button, spring and rod with hoop end. (Full assembly fine).
Would need to have it posted to North East of UK. DL5 5QB.
(Don`t want a repo` one).
Thank you.... P.
Got a couple here the ones with the balance bar so 65 onwards. 2nd class postagewill be cheap. Just need your address if you want one.
Will cancel the offer now that been through the box I have 2 later outers but 1 50's inner and button and the pivot lengths are different so the pawl will not release and dropping the inner the button shattered.
When do you need it - I am just about to swap mine out for a Megane one, probably within the week. Your's for the asking but not sure if the base has been altered to fit - but if you have that bit you are welcome to it.
(https://i.imgur.com/T3NmnfJ.jpg)
Quote from: snoopy on June 06, 2018, 02:51:07 PM
Got a couple here the ones with the balance bar so 65 onwards. 2nd class postagewill be cheap. Just need your address if you want one.
Will cancel the offer now that been through the box I have 2 later outers but 1 50's inner and button and the pivot lengths are different so the pawl will not release and dropping the inner the button shattered.
Thanks for looking Keith. Didn`t know there were differing versions. The Donor was `75 but being from Utenhage it has all sorts of stuff on it and cannot go by year or vin... found this out the hard way ;D
Quote from: fugglededumm on June 06, 2018, 07:08:01 PM
When do you need it - I am just about to swap mine out for a Megane one, probably within the week. Your's for the asking but not sure if the base has been altered to fit - but if you have that bit you are welcome to it.
(https://i.imgur.com/T3NmnfJ.jpg)
Thank you. Will take a gamble that it will fit. I would like it as soon as you can get it to me but a week or two`s wait won`t be a problem.
Will pm my address again
Came out easily - with a grinder 8)
These the bits you need ? - It is missing its Circlip and the pin is in there good and solid but easily sorted with a vice...
(https://i.imgur.com/HAMX3ck.jpg)
On it's way tomorrow for you!
Yes what I need. Don`t worry about the stuck pin. Have the circlips. Thank you for the rapid response but please let me pay you for this... ;-)up ;-)up ;-)up