Ah ha. I'm back and getting on with it.

The chassis was cut to bits to remove the rot etc and new floor pans put in. It was then treated to a nice smooth coating to finish off. We then slowly started to bolt all the bits back on but found that the refurbishing of some of these parts was time consuming. This meant I started to build a huge shopping list of new parts required.

So for the last few weeks I have been wheeler dealer-ing to get the best deals where possible.

These parts are slowly going on but am I am just waiting for a couple of key parts to arrive in the next few weeks so I can finish her off, just in time for the snow 

Here are a few photos:







When I get the next bits, I can start to bolt on most of the others, so will update after wards

That's looking really good enjoying see ing this built 

Looking Good