If anyone has these two items kicking around the garage floor or wherever else I need one of each,  just 1 wire wrist pin clip and just one distributor clip needs to be same design as the in the photo is off a vw bosch,

Hi Paul, I should have both but there are different length dizzy clips. Could you please measure it in between the two tight bends at each end!

Rob

Hi Rob, how are you, I thought it would be someone like you or snoopy that chirped up, the dizzy clip is for a German Bosch 009 for a type 1,  the distance straight across from the inside of the 2 tight bends is 36mm it needs to be the type that has the slotted/forked end that fits onto bracket, (I do have the bracket that screws to the dizzy), I'm going to need some advice at some point on what engine spec to go for with those engine parts I bought,  The heads have standard 32.5 exhausts but have larger 39mm inlet valves

Hi Paul, I grabbed 3 different length ones tonight before I came in and I see the one that was the right length had the wrong fitting on the end  Anyway I will have another look tomorrow, I'm sure I have one spare. If you want to message me your address, I'll get the bits in the post tomorrow. Really those heads are a bit of a waist of time on a road going 1600, with the larger inlet valves, it would loose drive ability at low rev's. Good for a race 1600 or larger engine. I'll buy them off you if you wanted to sell them 

Cheers Rob