Yippeee!

Thanks Mike for all this, am looking forward to getting it on Tuesday at work hopefully 
and its going to be a shock to my system after so many years with cannons.

Maybe though in the future, when they are finished with at their new home, I might swap them back..

Yet another GREAT reason to go all stainless! 

Peter 

I just want to say.....

My Sidewinder exhaust arrived today, and in every department its a work of art.

Quality of everything is something that gets missed a lot nowaday's, the welding is unreal....

And the hot air take of tube is just BRILLIANT 

Thankyou Mike, I am completely STUNNED at the quality of this thing 

Peter

Here's a photo 

And thanks for the amazingly clever heat supply to my carb... Its Brilliant   

I will tidy it all up though.....  As the corrugated tube's a bit messy:D

Does that just slip over the exhaust pipe? How does it draw air through to heat up?

Shaggy i left it to Peter, but im sure he has put a hole in it above the bulged section. no doubt Peter will correct me.

[HEAT]

For now I have left it just as it is...... Because I have found that the 'Heat' in there
flows all the way up to the carb all by itself. Heat rises 

And I am mixing the air in my filter cover with this stream of hot are thats rising. I put my hand up there today and the
corrugated pipe and filter cover were warm to touch, I may drill a couple of small holes in the bulged section at the 'bottom'
if I think the hot air that's in there and is rising could use some help, so far it hasn't needed it, though its not winter yet.

Remember, Its the HEAT I want, and mix it with the air 'up top' and so far its working brilliantly as is.

Having too large a hole or too many down the bottom only COOLS the hot air already in there....

This fitting Mike has made is a snug self supporting slide fit, the bulge in the middle means HEAT can warm the air
there and send itself upwards....

Peter